Check for a Manual
Check for a Brochure
Check for Installation Instructions
Check for Spare Parts Diagram
Check for MSDS
pH Buffer or Alkalinity Increaser for pools and spas. Contains: Sodium Bicarbonate
Make sure your pool or spa water is always balanced correctly so your sanitizer works effectively.
pH Buffer should be dissolved in a bucket of water and dispersed around the pool or spa.
Run the filter whilst adding the pH Buffer to ensure adequate distribution throughout the pool or spa water.
Allow 3-4 hours before testing the total alkalinity level again. Make further additions if necessary using the dosage rate as a guide.
PLEASE NOTE:
pH Buffer (Sodium Bicarbonate) is used to raise total alkalinity in swimming pool and spa water to “buffer” the pH. If totalalkalinity levels are too low, pH “bounce” (or excessive fluctuations) will occur. The minimum total alkalinity level in a pool orspa should be 60mg/L (p.p.m)
When purchasing, tap the edit cart link to see what freight you pay.
Due to high demand, we recommend reaching out to us directly for the most up-to-date stock.
Thanks for subscribing!
This email has been registered!
Take 20% off your first order
Enter the code below at checkout to get 20% off your first order