The all New Spa Electrics LED Multi Plus pool light represents a new generation in Multi Colour pool lighting.
With 5 different operating modes, the Multi Plus can operate via a standard wall switch or by using the Iris lighting controller. (Available Seperately)
The Multi Plus can also intergrate seamlessly with most pool automation systems such as Aqualink, Connect 10, Pentair Easy Touch & Zodiac Tri.
Along with this comes leading edge LED advancements with the introduction of an RGB+White LED array, providing beautifully clean white illumination and stunning colour shows never seen before in pool lighting.
Light Source Ceramic Light Engine (LED)
Available Colours MULTI PLUS
MULTI PLUS Compatibility Wall Switch Operation
iRIS Lighting Controller
AstralPool Connect 10®
Pentair IntelliTouch® / EasyTouch®
Zodiac/Jandy RS (REV R - Current)
IP Rating IPX8
Installation Types Concrete / Fibreglass / vinyl
Voltage GKRX 12~32v AC / WNRX 12V AC / EMRX 12V AC
Ambient Operating Temperature 5 °C to +40 °C
Warranty 12 Month Manufacturers Warranty
- Adapter plate suits most existing lights including Stroud, Waterco, Poolrite, Questa, Magic, Waterlinx, Dega, Swimworld & AquaQuip (Except tiled & Vinyl pools) & Spa Electrics SE3... refer to the below pic below to help ID your pool light...
The Spa Electrics MultiPlus retro light is designed to be a simple replacement light of your existing pool light. These new range of lights are multi voltage, so they will suit all existing installations where your existing light was either 12/24/32 volts.
The compact MultiPlus surface mounted light only protrudes 59mm into the pool and is switchable between colours by simply turning the light off then back on again!
The MuyltiPlus uses the latest technology in L.E.D lighting and we are confident in saying that it is the brightest underwater light available on the market.
The 'ceramic light engine' is slightly larger than a postage stamp yet it contains more than 200 L.E.D.’s. These LED’s are then encased in a ceramic housing which is then cooled via a heat sink thus allowing for greater light output.
It is an environmentally friendly product which requires virtually no maintenance and is well suited for both commercial and domestic applications, as it uses 75% less power when compared to a traditional Halogen light.
The Retro is adaptable to either Concrete or Fibreglass pools and will suit most major pool light brands.
No cable joining is required, by using our unique electrical connection you simply connect your existing cable to the light.
When purchasing, tap the edit cart link to see what freight you pay
Multi coloured pool lightBy: Adrian on 3 January 2022Excellent service at a very competitive price
Spa Electrics Retro Multi Plus Pool LightBy: Mari on 2 May 2019Bought these replacement pool lights fast delivery. Bought this brand as the old light are the same brand- The manufacture did an excellent job of getting many many other manufacurers lights and working our exactly how to mount thierse replacement lights, by the use a clearver designed backing plates. Easy to install no drilling needed, just remove old lights. from chart supplied choose your old lights that will show you which backing plate to use for your pool then assemble the units follow all instructions. its a bit hard to squezze the liquid get silicon into that small hall use a roll and pich method on the tooth past type tube, if you need use some flat plyers to assist the squeezing of the tube. You must wait for the silicon to come out the secont screw hole then you know its full as water wont get in to the electics, re insert the screws and then finish assembly of the light and install under water. All screws are supplied no need to get anyting else and excellent product. No you dont need the controller which is an over priced swithch. you can change then light colour or sych them but folllowing the instruction on swithcing the light sequence on and off until you get the desired colour you desire thats it