6 Pool Accessories to Fight Algae
Chemicals get the credit, but algae is beaten just as often with a brush, a shovel and a bit of routine. Here's the kit that keeps it from taking hold.
Algae doesn't need much to get going. A few spores, some warm water, a pile of leaves breaking down on the floor and a dip in chlorine is all it takes. Your sanitiser does the heavy lifting, but the right accessories cut off what algae feeds on, knock it off your surfaces before it settles in and clear out the mess once you've treated it.
Brush the walls
Weekly
daily during treatment
Phosphate target
Under 100 ppb
parts per billion
Free chlorine
1 to 3 ppm
home pools
The algae fighting kit
Some of these stop algae before it starts. Others are what you'll reach for when it's already turned up.
Algae brush
Algae is stubborn once it grips your walls and floor. Brushing weekly knocks spores loose before they can attach, which is the cheapest prevention you'll ever do. Pay extra attention to steps, corners and behind ladders, where circulation is weakest.
When you're treating an outbreak, brushing matters even more. It breaks down the protective layer algae forms, so your shock and algaecide can actually reach it. Brush daily until it's gone.
Manual vacuum kit
Plenty of pools rely on a robotic or suction cleaner, and that's fine for everyday debris. After an algae treatment though, you've got a floor full of dead algae that you don't want recirculating. That's a job for a manual vacuum: a telescopic pole, a vacuum head and a vacuum hose connected through your skimmer.
On a sand or media filter, set the multiport valve to Waste so the debris leaves the pool entirely. Cartridge filters don't have a waste setting, so vacuum through the filter and give the cartridge a thorough clean straight after.
Leaf shovel
A lot of algae problems start with leaves. As they break down they release phosphates, and phosphates are algae food. Leave that food source sitting on the floor and you'll be fighting the same bloom over and over.
A leaf shovel scoops leaves off the surface and, thanks to its angled front edge, picks up the soggy layer that collects on the floor too. Get them out before they break down rather than after.
Robotic surface skimmer
If you're surrounded by trees, a robotic surface skimmer is the next step up from a shovel. It works the top of the water all day, collecting leaves, pollen and bugs before they sink and start breaking down.
The Beatbot iSkim runs on solar power, so there are no cords and no extra load on your pump. It also takes pressure off your skimmer basket, which keeps flow through your filter where it should be.
Phosphate test strips
Regular water tests won't tell you about phosphates, and they're often the reason algae keeps coming back when your chlorine looks fine. Phosphate test strips give you a quick read on how much food is sitting in the water.
If your levels come back high, a phosphate remover strips that food source out so your sanitiser isn't fighting a losing battle.
Pool cover
The easiest way to deal with leaves is to stop them landing in the water at all. A leaf cover keeps debris out when the pool's not in use, and a pool blanket cuts evaporation and slows the rate your chlorine burns off in the sun.
Fewer leaves and steadier chlorine means algae has less to work with. Add a roller and the cover comes off in seconds, so it actually gets used.
Putting the kit to work
A simple weekly routine does more than any emergency treatment.
Clear the debris
Shovel out leaves, empty the skimmer and pump baskets, and let your surface skimmer handle the rest between visits.
Brush the walls and floor
Work from the waterline down towards the main drain so the debris ends up where your filter or vacuum can collect it.
Test your water
Check chlorine and pH weekly with your usual test kit, and run a phosphate strip every few weeks, or after storms and heavy leaf drop.
Cover it up
Put the cover on whenever the pool's not in use, especially before wind or rain.
Pool algae: common questions
How often should I brush my pool to prevent algae?
Once a week is enough for prevention. If you're treating an algae outbreak, brush daily until the water and surfaces are clear.
Do phosphates cause pool algae?
Phosphates don't cause algae on their own, but they feed it. High phosphates make it much harder for your chlorine to keep algae under control, which is why blooms keep returning.
Can I vacuum algae through my filter?
On a sand or media filter, vacuum to waste so dead algae leaves the pool. On a cartridge filter, vacuum through the filter and clean the cartridge thoroughly straight afterwards.
Does a pool cover help prevent algae?
Yes. A cover keeps out leaves and debris that break down into phosphates, and a blanket reduces how quickly your chlorine is lost to the sun.
Algae is far easier to keep out than to get out. Stock up on the basics before the warm weather hits. Start with an algae brush, a leaf shovel and phosphate test strips, with fast delivery across Australia.
Already fighting green water? Call us on 1800 648 363 and we'll help you get it back on track.